Always shake base coat, GelColor & Top Coat before use.

Before Recapping: Remove Gel from Bottleneck with NAS 99

For Maximum adhesion, to prevent streaks, blank spots, uneven colour results, shrinkage or heat sensation during curing:
Prep nails properly. Do not overload the brush. Polish on in thin coats. Cap free edges. Remove gel from cuticles and sidewalls prior to curing. Cure
Immediately after application.

Curing: Follow correct hand placement and cure times for OPI LED Light and Axxium UV Lamp.

Removal: Follow GelColor nail prep & removal instructions. Longer wear may increase removal time – Soak nails longer. Do not force or pull gel away from nail or use metal implements / electric drill to remove product.

Keep all GelColor products away from the LED lamp at all times. GelColor should not be kept close to a window or strong light and excess heat. Prolonged exposure to heat will crystalize the product and also discolour the GelColor.

For problems with Gel Lifting:
  • Check that the nail plate preparation has been carried out according to the OPI method and all the true cuticlue has been removed from the nail plate. For customers with a shiny, oily or flaky nail plate, buff gently with the OPI Flex 220/280 grit smoother.
  • Has Bond-Aid been applied? Dip the brush into the bottle for each.
  • Ensure all grease, dust and debris have been removed from the nail plate and the nail has been thoroughly cleaned with NAS 99 prior to applying the gel.
  • Ensure that the GelColor has been shaken enough prior to application
  • Has the gel been applied in thin, even coats?
  • Ensure that the free edges have been capped properly. Pay attention to the sides of the free edge on longer nail plates.
  • Has the gel been applied to the skin and not removed prior to curing?

Gel is wiping off after curing:
Check that the hand placement in the LED Light is correct and that the fingers are spread out and making contact with the sensor plate.

Gel is dull at the end of the treatment:
  • Ensure that the Top Coat has not been applied too thinly or an area of the nail has been missed during the application.
  • Fingers may not have been placed in the LED Light accurately.

Gel in uneven and streaky:
This could be because the gel has not been applied in thin even coats. If better colour coverage is required, it is better to apply 3 thin coats of colour rather than 2 thicker ones.

Gel is thick and bulky:
  • Too much gel has been applied. To get the best results apply the gel to the nail, then wipe any excess gel from the brush and wipe the brush over the nail using light, even pressure and remove any excess.
  • Cap the free edge.
  • Gel will self-level and roll out to the side walls of the nails. So make sure that the gel is not over applied in this area.

Gel is taking too long to remove:
  • Ensure that the removal pad is saturated with remover.
  • The foil wrap should be applied tightly to prevent the pad from drying out and hands are placed in disposable gloves.
  • GelColor that has been on for a long period of time may require a slightly longer soaking time than usual.

Gel is shrinking back from the cuticle and free edges:
  • Ensure that the base coat is applied evenly and thinly to the entire nail plate. If you apply colour to areas where the base coat has not been applied, the gel will shrink back to where the base coat has been applied.
  • Prior to applying any of the gel layers, cap the free edge and then apply the gel to the nail in thin coats, brushing over and down the free edge.
  • Apply the gel quicker with a light, even pressure, ensuring that the gel is pushing down on the cuticle area.

If your question is not answered above please email us at tradeasktheexpert@lenawhite.co.uk


LiveObjects